Tershine Amplify – Wet Coat 5 L

Paint protect your vehicle in no time, spray on wet surface and rinse off!

Creates huge runoff and lots of shine
Dilutable
Extremely easy to apply
Works on all surfaces and vehicles
Long shelf life
The product is produced without the addition of per- and polyfluorinated substances (PFAS)
The product is not classified as requiring labeling according to CLP Regulation (EC) 1272/2008.

How to use Amplify – Wet Coat 

1. Wash the vehicle with all steps, avoid shampoos with run-off such as Purify S+ etc (can be a bit too much of a good thing)! Of course you can, but then dilute Amplify with water to be on the safe side. 
2. Spray on wet surface
3. Rinse thoroughly.
4. Dry with a microfiber cloth of your choice
5. Yes, we know, it's completely crazy!

Very easy to use and gives fantastic drainage, shine and protection without any frills. Works equally well on wraps, PPF, matte paints, plastic, glass and rims. You don't feel anything in your eyes, lungs etc. as you can easily do with stronger chemicals! Works great when diluted all the way up to 1:10 (affordable!).

Smells fantastic of some exotic fruits, think Fanta Exotic (ish). Works on pretty much all materials such as paint, glass, plastic, gelcoat, aluminum, rubber, etc. Keep in mind that the product is very generous so a little goes a long way, as I always advocate. Experiment to find out what you like and feel free to test on one panel at a time before you get to know the product. As usual with our products, less is more!

Ps. Of course, it can also be used on a dry car as a quick
details and you can also dilute it up to 1:10, but feel free to experiment with what you like best yourself. It all depends on how good the base is, if you have all our protection underneath such as Magnify – Coating, Refract etc then diluting it works fine. But, it is intended to be used as it is so again, feel free to try what you like best yourself. Please avoid direct sunlight when using, of course this applies to all car care products.

Tip: Make sure the surface is cool and thoroughly cleaned (rinse thoroughly). Always start with one or two panels and then rinse off so you know how it works in your particular environment. Remember that it is super-potent, less is more and avoid sun/wind.

If, against all odds, any kind of flame should occur, just buff it away when you dry the car with the microfiber cloth or if it has already hardened, the easiest way is to use a damp cloth and Apex+! If that doesn't work, sponge in Dissolve or, ideally, Prime – Panel Wipe and it will disappear.

Keep in mind that if you are outside, wind and heat will accelerate the flash time. If you are a little unfamiliar with the product, feel free to use one or two panels at a time and then shower off.

Please avoid Purify S+ or other shampoos with "Coating" before use, they usually work but can be a bit too much of a good thing! The first few times you try it, you might want to start with one panel at a time or dilute it a little until you are satisfied.